![]() We fed the audio signal to a JL Audio FiX-82 integration processor. We measured the frequency response of the amp output to ensure we had the entire audio spectrum covered. With the console out, we had access to the wiring from the factory amplifier. We started by removing the door panels and center console from the truck. Armed with this knowledge, the client agreed that we would leave the factory radio in the dash, then use a premium signal processor to extract audio from it. Choosing better speakers and subwoofers and a more powerful amplifier represents a greater improvement in performance. ![]() Regarding overall system performance, it adds a lot of expense for minimal return on investment. ![]() The factory radio in the F-150 is a bit complicated to replace. The resistors were soldered on and then heat-shrink was applied for protection.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |